Wiring Panel PGM outputs to Radio
Posted: Sun Mar 07, 2021 9:17 pm
See below images to wire a control panel to Armed response radios(installers also included)
Radio MUST be powered from battery power
Two ways, either using a single pole relay or a PGM buffer or a PGM converter
Programming on PGM should be around 3 seconds for the event
For Paradox panels there should not be a deactivation event(disabled), PGM to be N.O. programmed, PGM is timed
See circled red jumper selection + or - notes.
Radio MUST be powered from battery power
Two ways, either using a single pole relay or a PGM buffer or a PGM converter
Programming on PGM should be around 3 seconds for the event
For Paradox panels there should not be a deactivation event(disabled), PGM to be N.O. programmed, PGM is timed
See circled red jumper selection + or - notes.